Easy To Use Lily58 Kit Device [N28fg4zR]

Designed by kata0510, the Lily58 is a split design with a 6×4 column staggered grid with a 4-key thumb cluster. 

Hotswap Kits require soldering
The Ready2Go does not require soldering, but still requires switches and keycaps.
The Pre-Build comes fully built and flashed, only requires a USB-C cable.
Please see the specifications below for additional information.

Wired build guide can be found here (This links to the Sofle build guide but the steps are the same)
Wireless build guide can be found here (This links to the Sofle build guide but the steps are the same)

The Kits

Both the wired and wireless kits contain all you need to solder and build your own Lily58. The only things you'll need are 60 switches, 2 controllers and a set of keycaps!

Both Wired and Wireless included:

• Hotswap PCBs (Black)
• Switch Plates (FR4)
• Bottom Plates (Frosted Acrylic)
• Diodes
• Hotswap Sockets
• Reset Buttons
  
• Mill Max Socket Pins
• Controller Sockets
• Acrylic Screen covers
  
• Screws and Standoffs
• Adhesive Rubber Feet
  

Wired kit additionally includes:

• OLED Screen and Sockets x 2
  
• RP2040 Controller x 2
• TRRS Jacks
  
• TRRS Protection Diode/Resistor
• Basic TRRS Cable

Wireless kit additionally includes: 

• nRF52840 BLE Controller x 2
• Battery x 2
• MIP Display x 2
• SMD Power Switches

Switches and keycaps are not included.

Useful links
3D-Printed Cases
Stainless Steel Backplate
QMK Configurator
VIA Configurator
VIA Firmware

*Do not hotplug TRRS cables while your keyboard is powered as this can cause permanent damage.

Please see the specific version specifications below.