Experience Custom Drawer Divider, Maple Silverware Organizer, 10 Spaces, Drawerspace X1c6x1 Custom Made For Your Exact Dimensions. With Tracking [qOHzU4jR]

Cabinet drawer organizer with ten total spaces, custom made for your drawer size.

Do your drawers need custom made dividers? Does your kitchen deserve better than what is in there now? Do your items want to be organized in a thoughtful way with no wasted space?

----------------------------------------------------------

DrawerSpace X1C6X1:

Left side:

1 vertical space (going from front-to-back), width = 4". This dimension can be made any number you'd like, by specifying in the "personalization" section when ordering. A knife block accessory can be added in this section for an extra $50.

Front: 2 equal width spaces at the front, 3" deep The width's are minus the spaces on the left + right + thickness of the maple sides, and is determined by your drawer width dimension,. The depth dimension can be different than 3", and can be specified in the "personalization" field when ordering.

Rear: 6 equal width vertical spaces..

Right side:

1 vertical space (going from front-to-back), width = 4". This dimension can be made any number you'd like, by specifying in the "personalization" section when ordering. A knife block accessory can be added in this section for an extra $50.

Height:

The height is fixed at just under 3" high (2.905"), which will be optimal for most drawers.

Width maximum is 35" wide, with a bottom. Wider than 35" is available without a bottom, and made shorter at 2.2" high.

----------------------------------------------------------

How it's made:

DrawerSpace custom inserts are made with 1/2" thick solid maple sides, and 1/4" thick solid maple center dividers. The bottom starts with Formica laminate, that has a matching natural maple pattern. This is for durability and scratch resistance. The same laminate is on the top and bottom surfaces, and covers 3/8" thick board for stability. The entire bottom is fully captured and glued into a dado in the sides.

All joinery is mortise and tenon.

See below for a diagram of the 5-degree taper around the sides, which is done to clear any screws that may protrude into the drawer interior from your decorative hardware. if we had straight sides, you would need extra wiggle room (and wasted space) to allow for screw heads.

----------------------------------------------------------

Lead time:

Your custom made DrawerSpace insert will be built and shipped within three weeks of order placement.

----------------------------------------------------------

Where it is made:

The entire process is done in Sunset Park, Brooklyn, NY!

----------------------------------------------------------

How to order:

Above is where you can enter your inside drawer dimensions, under "Personalization" .

We also have a "No Measuring" option, for those who are not comfortable with a tape measure.

Send a message via "Send Message" link below, and we will send a link to the video instructions.

----------------------------------------------------------

Thank you! Hope we can help provide the joy that your new beautifully organized drawers will bring you! -Gary

.