As Seen On Tv Jevries Ultra Fast Superpumps Apparel [BmOPYk2L]

SKILL LEVEL III EXPERIENCED USERS ONLY!

These New ULTRA FAST Pro-Series Superpumps are developed for RC Lowriders with either a single or double servo hopper setup and makes your car hit backbumper hard at 9V!

The ULTRA FAST pro-series Superpumps have a crazy amount of speed and torque.
45KG 0.06sec at 8.4V!!

The ULTRA FAST 4-pole Brushless motor delivers ultra torque and highest durability, more efficiency for faster response. Extremely tough and durable.
Build to Last.

NOTE:
- These super fast and strong servo's are for EXPERIENCED users only! 
- Always adjust the endpionts first prior to connecting the links and mounting the servo horns to make sure there's no binding (humming noise).

For Best results you need the Jevries 20A BEC set at max. 9V and 3S lipo battery.

 Powered by AGFRC!

Specs:
Voltage: 7.4V- 8.4V (9V)
Gears: Super Steel Pro Gears
Bearing: 3 HQ Ball Bearings
Operating Temperature: -15°C - +70°C
Pulse / Frequency: 1520uS/ 333Hz
Operating Speed: 0.07sec/60° @ 7.4V 0.06sec/60° @ 8.4V
Static Holding Torque: 39kg-cm (542 oz-in) @ 7.4V 45 kg-cm (625 oz-in) @ 8.4V
Size: 40*20*37.2mm 1.57*78*1.46inch
Motor Type: 4 Pole Brushless
Spline: 25T/ Dead Band Width 2uSec


Here's some pointers for Best performance:
- Set endpoints at 50%-50% WITHOUT the servo horn(s) on. When done mount the servo horns and connect the levers and set the endpoints so that the servo(s) don't bind.

- Use the third hole (20mm) on the Jevries servo horn this creates a nice balance between speed and torque.

- For single servo setup mount the servo with servo horn facing forward and use the third hole (20mm) of the Jevries servo horn. 

- For best results on a double servo setup I suggest to use RC Hop Shop aluminum double servo mount. Mount the servo's upside down in the mount as shown in the picture.

- For best hopping you either need to use a shaved driveshaft or neutral mod.

- Use a good set of medium/stiff shocks to make sure the car doesn't bottom out.

WARRANTY DOES NOT COVER BURNED OUT OR LOCKED UP SERVOS DUE TO IMPROPER HANDLING AND INCORRECT ENDPOINT SETTINGS!!
BURNED OUT and LOCKED UP SERVOS ARE CAUSED BY INCORRECT ENDPOINTS SETTINGS, THE USE OF HIGHER VOLTAGE AND/OR THE SERVO HORN(S) GETTING STUCK BY SOMETHING LIKE A LOSE BOLT OR WIRING.