Thanksgiving Deal Flash Deals Flipsky 75200 Pro 84v High Current With Aluminum Pcb Based On Vesc For Fighting Robot Surfboard Agv Robot Pro Version [UbQEsXlG]

Warm tips:

It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC.

Specs:

• Firmware: 5.2, supports firmware upgrade
• Voltage: 14-84V (safe for 4-20S)
• Continuous current: 50V/200A; 75V/150A (Values depend on the mounting, ambient temperature and air/water circulation around the device!);
• Burst: 300A
• BEC: 5V@1A
• Support Modes: DC, BLDC, FOC (sinusoidal)
• ERPM: 150000
• Communication Ports: USB, CAN, UART, SPI, IIC
• Supported Sensors: ABI, HALL, AS5047, AS5048A
• Input Source Support: PPM, ADC, NRF, UART
• Supported Sensorless: Yes
• Regenerative capacity: Yes
• Programmable via VESC_TOOL: Yes
• 75200 Pro Size:130x67.7x39..4mm
• Motor/power wire size: 8 AWG

Features:

• Adjustable protection against: low voltage protection, high voltage protection, over current protection, temperature abnormal protection, mosfets / motor over temperature protection.
• Support various control modes: Current / Duty cycle / Speed / PID control modes.
• Support the function of balancing car by connecting the IMU module through the IIC interface;
• support inertial measurement unit modules such as MPU9250, MPU9150, MPU6050, LSM6DS3, BMI160.
• CPU:32F405 with frequency 168MHz
• Aluminum PCB with good heat dissipation to expand life span.
• 75200 Pro aluminum substrate single drive: supports single serial port function,and integrates Bluetooth module function (convenient to connect Bluetooth parameters and read data in real time)

Warm tips:

Wiring diagram：