Bestselling Zone Offroad D39 6 Inch Coil Spring Lift Kit - 4 Inch Rear Axle | 2009-2013 Dodge Ram 2500/3500 4wd Gas Accessory [WT462IR9]

Features:

• 100% bolt-on design for easy installation.
• High-strength control arm relocation brackets correct suspension geometry and add rigidity.

Description

Built to provide a full 6" of lift for clearance of up to 37" tires, this lift kit corrects suspension and steering geometry so your truck drives and handles great with more capability offroad. Get the look and performance you want out of your 4WD 2009-2013 Dodge / Ram 2500 / 3500 Truck.

Vehicle Fitment:

• 2009-2012 Dodge Ram 3500 4WD/Gas
• 2009-2013 Dodge Ram 2500 4WD/Gas
• Fits models with 4" rear axle

Quick Specs:

• Front Lift Height: 6"
• Rear Lift Height: 4"
• Front Lift Method: Coil Springs
• Rear Lift Method: Cast Blocks
• Lift Type: Lift Kit
• Wheel Size: 17 x 9
• Back Spacing: 5"
• Max Tire Size: 37 x 12.5
• Wheel Size 2: 18 x 9
• Back Spacing 2: 5"
• Max Tire Size 2: 37 x 12.5
• Wheel Size 3: 20 x 9
• Back Spacing 3: 5"
• Max Tire Size 3: 37 x 12.5
• Finish: Powdercoat
• Cutting Required: No
• Accommodates Factory Wheels: See Notes
• Welding Required: No

Important Notes:

• Will work with Power Wagon models with the addition of sway bar link kit D5301. Power Wagon models came factory with a 2” taller ride height, so net lift gain will be 4” over stock.
• Check Rear Axle Diameter: This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
• Driveline Notice: Although rare, if you experience front driveline vibration, install the optional transfer case indexing ring.
• Fitment: This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
• Gas models may require modification to the front exhaust crossover pipe on driver side when using the transfer case indexing ring.
• Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
• Wheels / Tires: Adding larger-than-stock wheels? Add front bumper spacers to your kit for additional clearance as some wheel / tire combos may not fully clear the bumper’s stock location.
• Works on 2013 2500 with 4 link front suspension only. Will not fit 1 Ton Trucks.

In the Box:

• All Necessary Mounting / Installation Hardware
• Brake Line Brackets
• Coil Springs
• Control Arm Relocation Brackets
• Dropped Pitman Arm
• Rear Lift Block & U-Bolt Kit
• Track Bar Relocation Bracket